FLIR F-Series Installation Manual page 16

2—Verify Camera Operation
Step 4 When the Discovery Panel is displayed, click Refresh.
The FLIR camera will appear in the list of Discovered Servers. The camera will be
called "flir", and the asterisk in parenthesis "(*)" indicates the camera has not been
added to the list of Active Servers on the right.
Step 5 Click on the center bar ">" to move the camera over to the list of Active Servers on
the right as shown below.
Click
Click
Once the camera has been added to the list of Active Servers, you can click on the
Discovery button again to close the Discovery Panel.
By default, the FSM software will automatically discover sensors in the network,
connect to the first camera it finds, take control of the camera, and display the video
from the camera in Video Wall 0 on the main FSM window.
Step 6 Confirm that video is streamed to the monitor and it is possible to control the camera
using the zoom controls and so on. For example, click on the zoom button (magnifying
glass with +), and the video will zoom to 2X. Once operation of the camera has been
confirmed, the camera can be configured to an IP address that matches the
installation network.
Step 7 Return to the Web Configurator screen
shown at the right and enter basic as the
User and click Login.
No password is required.
The Web Configurator will display the Help
screen listing information on the camera's
software and hardware configuration.
The menu on the left allows you to select
various configuration web pages in order to
set the camera parameters. See "F-Series
Configuration" on page 2-5.
2-4 March 2010
F-Series Installation Manual
427-0030-00-12, version 110