Reconnect Your Module; Install Your Module - Verizon Delphi Connect 4G LTE ACT233L User Manual

• If you still do not see the Dashboard screen, see the Troubleshooting section of this guide.

Reconnect Your Module

If you are installing the module for the first time, please refer to the instructions for First-Time
Setup.
If your device becomes disconnected from your vehicle or the battery is disconnected from your
vehicle, you will need to re-initialize the module with your vehicle. In this case, please complete
the following steps.
Note: If you are re-initializing the module to a vehicle that you have previously used with the
module:
• The vehicle history will be available for all times the Module was connected
• If you paired the keyfob previously to this vehicle, it will remain paired once reconnected

Install Your Module

1. If you are currently using the app on your Verizon Wireless smartphone, use your smartphone
to check that you have a strong signal where your vehicle is parked. Don't have Verizon
coverage? Visit Verizon's interactive coverage map: verizonwireless.com/maps.
2. Make sure your vehicle is parked outside in a safe location and the engine is turned off.
3. Now plug the module into the OBD port (or into the extension cable if it is required). Make
sure that the module is fully seated.
Helpful Installation Tips:
• If the module seems to be difficult to insert, DO NOT FORCE IT, remove the device and
examine both connectors for any bent pins.
38