Sharp MX-2615N Configuration Manual page 51

Step 2: chooSe finiShing configuration
Configuration A: 50-sheet Staple Finishing
A
This configuration requires the MX-M904 and the
MX-FN24 or MX-FN25. The MX-FN24 cannot be used
with the MX-FN25. The MX-PNX4B can be added, but
cannot be used alone. These items cannot be combined
with items from other finishing configurations.
Configuration B: High Capacity Stacking
B
This configuration requires the MX-RB18 and
one MX-ST10. An additional MX-ST10 can be added,
but is not required. Each MX-ST10 includes one
MX-CA10 Paper Cart. Additional paper carts can
be ordered for convenience. The MX-SL10 Status
Indicator can be added to any configuration.
Configuration C: Basic 100-sheet Staple Finishing
C This configuration requires the MX-RB18 and the MX-FN21 or MX-FN22.
The MX-FN21 cannot be used with the MX-FN22. The MX-BM50 requires
the MX-FN21 and MX-PCB50. The MX-FD50 must be connected to the
MX-TM50. The MX-SL10 Status Indicator can be added to any configuration.
Plockmatic Production Booklet Maker System
Exit Tray Included MX-CF50
with MX-BM50 Cover Feeder
and
MX-FD50 MX-TM50
Square Fold Face Trimmer
Module Module
MX-XB50
Rail Unit (recommended)
© 2013 Sharp Electronics Corporation. All rights reserved.
mX-m904/m1054/m1204
MX-ST10
High Capacity
Stacker
(not required)
and
and and
MX-BM50 MX-PCB50
Booklet Maker Plockmatic
Interface Kit
and
MX-PNX4B
3-Hole
Punch Unit
or
MX-FN25
Saddle Stitch
Finisher 2K
(50-sheet staple)
and and/or
MX-ST10 MX-CF11
High Capacity 2-Tray
Stacker Inserter Unit
MX-TM10
Trimming Unit
MX-PN13B
3-Hole
Punch Unit
and or
MX-FN21 MX-FN22
Finisher 4K Saddle Stitch
(100-sheet staple) Finisher 4K
(100-sheet staple)
configuration chart
A
MX-M904
MX-FN24
Finisher 3K
(50-sheet staple)
and
B
MX-SL10
MX-RB18
Status Indicator
Curl Correction
(optional)
Unit
MX-M904/M1054/M1204
and
C
MX-RB18
Curl Correction
Unit
51