Sharp MX-2615N Configuration Manual page 25

S 2: c
tep hooSe finiShing configuration
Configuration A
A The MX-TU14 must be installed if no finishing
options are selected. This item cannot be combined
with items from other finishing configurations.
Configuration B
B
These configurations require the MX-RB12 and
a finisher, but do not require the MX-PN12B.
The MX-FN19 cannot be used with the MX-FN20.
These items cannot be combined with items from
other finishing configurations.
Configuration C
C
These configurations require the MX-RB12, MX-RB15 and a finisher.
The MX-RB13 cannot be used with the MX-FD10. The MX-FN21
cannot be used with the MX-FN22. These items cannot be
combined with items from other finishing configurations.
MX-TM10
Trimming Unit
MX-PN13B
Punch Unit
or
MX-FN22 MX-FN21
Saddle Stitch Finisher 4K
Finisher 4K (100-sheet staple)
(100-sheet staple)
*A Relay Unit or Folding Unit is required to connect a Finisher and Inserter directly.
© 2012 Sharp Electronics Corporation. All rights reserved.
mX-6240n/7040n c
or
MX-FN20
Saddle Stitch
Finisher 4K
(50-sheet staple)
and or
MX-FD10* MX-RB13 *
Folding Unit Relay Unit
onfiguration chart
MX-TU14
Exit Tray Cabinet
and/or
MX-PN12B
MX-FN19
Finisher 4K Punch Unit
(50-sheet staple)
and/or and
MX-CF11 MX-RB15
Inserter Curl Correction Unit
A
MX-6240N/7040N
B
MX-RB12
MX-6240N/7040N
+ MX-RB12
Paper Pass Unit
(required for Configurations
B and C)
C
25