Table of Contents
Advertisement
The following chart shows the system functions with the "Heat/Cool" thermostat. Disregard refer-
ences to heat functions when using the thermostat in the rear bedroom.
TV ANTENNA
The TV antenna on your motor home can be
easily raised, rotated a full 360° and lowered
from inside the vehicle by simply turning a crank
or rotating knob. A built-in signal amplifier de-
signed to strengthen signals, is controlled by a
power switch built into the TV jack assembly.
The signal amplifier is housed inside the an-
tenna with the circuit board connected directly to
the antenna elements. Power to operate the am-
plifier (12-volt DC) is supplied through the
downlead cable which also carries the TV signals
to the TV set. The power supply separates the 12-
volt DC from the TV signals and provides a place
for attaching the TV set and the 12-volt power
source.
APPLIANCES & INTERIOR FEATURES
Operation
Operation
Raising Antenna - Turn elevating crank
clockwise in "UP" direction about 13 turns or un-
til some resistance to turning is noted. Antenna is
now in operating position. Turn amplifier power
switch "ON" to receive TV signal.
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
SECTION 8
WARNING
8-13
Advertisement
Table of Contents
