Table of Contents
Advertisement
Water And Holding Tank Levels
Press and hold the "Levels Test" switch to
show approximate level on the monitor lights.
These approximate water levels are measured
by electronic probes in the sides of the tanks, so
the water must be touching a probe to register at
that level. There is generally more water in a tank
than indicated on the monitor panel.
For example, if the water level of 1-2" below
the FULL probe, the monitor will show the level
to be only 2/3 even though the tank is nearly full.
If the water level is below the 1/3 probe, the mon-
itor will register an empty tank because the water
is no longer touching the 1/3 probe. There may
actually be some water left in the tank. However,
when the indicator reads FULL, the tank is actu-
ally full.
LP Gas Level
Press and hold the "Levels Test" switch to
show approximate LP tank level.
The LP level is registered by a sending unit on
the tank. The gauge mounted on the side of the
tank will give a more accurate indication of actu-
al tank level if needed.
Water Pump Switch
When use of the self-contained water system
is desired, turn the "Water Pump" switch on. The
"Pump On" light will illuminate when the pump
switch is on and the system is operable. Water
will be available as soon as a faucet is opened.
Refer to "Fresh Water System" for additional in-
formation on the water pump and initial start-up.
APPLIANCES & INTERIOR FEATURES
Battery Condition Meter
Push the "Levels Test" button to check the
level of charge (voltage) in the 12-volt coach
battery. The colored segments (red, yellow and
green) will light from the bottom up to the
amount of charge the battery contains.
∗ Green - good or adequate charge.
∗ Yellow - marginal charge.
∗ Red - battery needs charging before use.
Water Heater Switch and "W.H. Pilot" Indi-
cator
Be sure the water heater is filled with water
before pressing this switch. To fill the water
heater, turn the water pump switch on and open a
hot water faucet until water begins to flow.
The "W.H. Pilot" light will glow for about
10-15 seconds after the water heater switch is
turned on, then it will go off.
If the "W.H. Pilot" light comes on during
normal operation, it means that the burner has
gone into "lockout" mode. Turn the switch off
for about 5 minutes, then turn back on.
DIRECT IGNITION GAS
WATER HEATER - 6 Gallon
1. Place Water Heater switch in the "On" posi-
tion. The switch and "WH Pilot" light are
located on the lower face area of the galley
cabinet.
SECTION 8
8-7
Advertisement
Table of Contents
