2-1 Setting Up For Use Over Wired Lan - Canon PIXMA MX850 series Quick Start Manual

2-1 Setting Up for Use over Wired LAN
(continued from step 12 on page 22)
~ Important
When the machine has not been connected to the network, to set up the machine to be used from a LAN-
connected computer, the necessary software must be installed on the computer. See "1 Preparing for
Setup" on page 17 and "2 Installing the Software" on page 18 to confirm that the software installation is
complete, then proceed with the procedure below.
1
On the Canon IJ Network Tool screen,
select LAN connection, then click OK.
If the Canon IJ Network Tool does not start up
automatically, select Library> Printers> Canon>
BJPrinter> Utilities> Canon IJ Network Tool.
~
Note
If you select USB connection, the Canon IJ Network
Tool will exit without setting up the machine to be used
over wired LAN.
If the screen shown on the right appears, make
sure of the following, then click OK.
- The machine is turned on.
- The machine is connected to the computer with a
USB cable.
- The MP Drivers have been installed.
2
Select Setup in the pop-up menu, select your
machine's name in Printers, then click OK.
if you plan to
\.IS.,
the. ptIDter with
II
US! <;~". $;!~ct [USJ conoectiorr}, arn:f lhen
dlclc.IOkj.
The. wtup will be complete.
If yw
1'1"0
to use thfo pMler
with
a LAN
{;Of'Intctlofl,
selecllLAN: connection}, a~
t~n
elk. (OKI. Then, configure. the printer network Stithtys.
i
use
connection
( _ tAN conne«iOn )
- -,...~
.
. . . . . ' . - - When HttI .. "9
\fp.
via usa.
oteiJiC!
conflrm 1M
" : follow1:nv _
_ _ ' ~ 1M p'U~t lJrwerl$ !P.1WIed
. Th~ pnnfl!r is 'umt'd on.
-The VS8 abk is COtlnt<Ud Cl)(.'tetly.
C ••
U,)
'--'~~c<k--_:ca-"&",,~:;:!:&w~j.d~k.t>LL;;;tiLL;;:Li::'
(~ ~)
..
Printen-:
~
Note
• If no printer is detected, click OK. Make sure of the
following, then click Update.
- The machine is connected to the computer with a
USB cable.
- The machine is turned on.
• If the machine's network settings are already
configured, the Setup Environment Confirmation
dialog box appears asking for your confirmation to
use the machine with the current settings. You can
proceed with the setup using the current network
settings. To do so, click Use as is. To reconfigure
the network settings, click Reconfigure.
TaL, . . mm em
(~~H---) <_i:'~~~~_~:~_~~;;:
select tne printer you want to set up for the network, and men clidt lOKI. If
.,.ou plan
to connut rlw printillr
with a
usa
cabHt or
u'e ttl..
printer
that
hal
boM!n set up
fot ttt.
network, dick fltglsttr Printer} and ildd a
prIn~r.
)
Setting Up the Machine and the Computer (Macintosh) 23