An Error Message Is Displayed On The Lcd - Canon PIXMA MX850 series Quick Start Manual

An Error Message Is Displayed on the LCD
If an error message is displayed on the LCD, take the corresponding action described below.
Message
I
Action
I
"The ink may have run out. Replacing
If the lamp on the ink tank is flashing, ink may have run out.
the ink tank is recommended."
Replacing the ink tank is recommended.
U041
If printing is in progress and you want to continue printing, press the OK button
with the ink tank installed. Then printing can continue. Replacing the ink tank is
recommended after the printing. The machine may be damaged if printing is
continued under the ink out condition.
See "Replacing an Ink Tank" on page 107.
W
Note
• If multiple ink lamps are flashing red, see "Getting the Ink Status Information"
on page 107 and check the status of each ink tank.
• Since printing in this condition may cause the contents of the fax to be lost,
the machine stores received faxes in memory without printing until the ink
tank is replaced. Print the fax stored in memory manually after replacing the
ink tank. You can set the machine to print received faxes forcibly without
storing them in memory, but a part of contents or all contents of the fax may
not be printed.
"Print head is not installed. Install the Follow the directions given in your setup sheet to install the Print Head.
print head."
If the Print Head is already installed, remove the Print Head once and then
U051
reinstall it.
"The type of print head is incorrect. If the error is not resolved, the Print Head may be damaged. Contact your
Install the correct print head." Canon service representative.
U052
"Some ink tanks are not installed in Possible causes are as follows:
place."
• Some ink tanks are not installed in the correct position. (The lamp on the ink
U072 tank flashes.)
"More than one ink tank of the following • More than one ink tanks of the same color are installed. (The lamp on the ink
color is installed." tank flashes.)
U071 Confirm that the ink tanks are installed in the appropriate positions.
See "Replacing an Ink Tank" on page 107.
"The remaining level of the ink cannot The remaining ink level cannot be correctly detected. (The lamp on the ink tank
be correctly detected." flashes.)
U130
Replace the ink tank and close the Scanning Unit (Printer Cover).
Printing with an ink tank that was once empty may damage the machine.
If you want to continue printing in this condition, you need to release the function
for detecting the remaining ink level. Press and hold the Stop/Reset button for
at least 5 seconds, and then release it.
With this operation, releasing the function for detecting the remaining ink level is
memorized. Please be advised that Canon shall not be liable for any machine
malfunction or damage caused by refilled ink tanks.
See "Replacing an Ink Tank" on page 107.
W
Note
--
• If the function for detecting the remaining ink level is disabled, the ink tank in
gray is displayed on the LCD when checking the current ink level.
See "Getting the Ink Status Information" on page 107.
• Since printing in this condition may cause the contents of the fax to be lost,
the machine stores received faxes in memory without printing until the ink
tank is replaced. Print the fax stored in memory manually after replacing the
ink tank. You can set the machine to print received faxes forcibly without
storing them in memory, but a part of contents or all contents of the fax may
not be printed.
TroubleshootinQ 133