Fuse; Storage Compartment/Tools - Arctic Cat 150 2013 Operator's Manual

1. Remove the rubber boot from the
back of the headlight housing;
then remove the three-wire con-
nector from the bulb.
2. Release the two ends of the spring
clip from the headlight housing
taking care not to bend or deform
the clip; then remove the bulb
from the housing.
3. Install the new bulb into the housing;
then secure with the spring clip.
4. Connect the three-wire connector
to the bulb; then install the rubber
boot.
5. Install the wiring harness connector.
CAUTION
When replacing the headlight bulb,
be careful not to touch the glass
portion of the bulb. Grasp the new
bulb with a clean cloth.
To replace the running lights, use the
following procedure.
1. Pull the bulb socket from the running light housing and remove
the bulb by pulling it from the socket.
2. Push a new bulb into the socket and press the socket into the run-
ning light housing.
52
To replace the brakelight bulb, use the following procedure.
1. Turn the bulb socket counterclockwise to unlock and pull it out of
the light housing.
2. Push the bulb in and turn it counterclockwise.
3. Install the new bulb by turning it clockwise while pushing in; then
place the socket into the light housing and lock by turning it
KM194A
clockwise.

Fuse

The main (20 amp) fuse is located in
a fuse holder near the battery under
the seat.

NOTE: To replace the fuse,
open the holder and remove the
KM192A
fuse; then install the new fuse.
A spare fuse is located in the
battery hold-down.
If there is any type of electrical system
failure, always check the fuse first.
Always replace a blown fuse with a fuse of the same type and rat-
KM195
ing. If the new fuse blows after a short period of use, consult an
authorized Arctic Cat ATV dealer immediately.

Storage Compartment/Tools

A basic tool kit is provided with the ATV. It is located under the seat.
Maintain the tool kit with the ATV at all times.
CAUTION
KM854A
KM863