Fuse; Storage Compartment/Tools - Arctic Cat 2012 ATV 150 Operator's Manual


NOTE: The bulb portion of the
headlight is fragile. HANDLE WITH
CARE. When replacing the head-
light bulb, do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a
dry cloth before installing. Skin oil
residue on the bulb will shorten the
life of the bulb.
To replace the headlight bulb, use the
following procedure.
1. Remove the rubber boot from the
back of the headlight housing;
then remove the three-wire con-
nector from the bulb.
2. Release the two ends of the
spring clip from the headlight
housing taking care not to bend
or deform the clip; then remove
the bulb from the housing.
3. Install the new bulb into the hous-
ing; then secure with the spring clip.
4. Connect the three-wire connector
to the bulb; then install the rubber boot.
5. Install the wiring harness connector.
CAUTION
When replacing the headlight bulb, be careful not to touch the
glass portion of the bulb. Grasp the new bulb with a clean cloth.
To replace the running lights, use the following procedure.
1. Pull the bulb socket from the running light housing and remove
the bulb by pulling it from the socket.
2. Push a new bulb into the socket and press the socket into the run-
ning light housing.
To replace the brakelight bulb, use the following procedure.
1. Turn the bulb socket counterclockwise to unlock and pull it out
of the light housing.
2. Push the bulb in and turn it counterclockwise.
KM194A
3. Install the new bulb by turning it clockwise while pushing in;
then place the socket into the light housing and lock by turning it
clockwise.

Fuse

The main (20 amp) fuse is located
in a fuse holder near the battery
under the seat.
KM192A

NOTE: To replace the fuse,
open the holder and remove
the fuse; then install the new
fuse. A spare fuse is located in
the battery hold-down.
If there is any type of electrical system
failure, always check the fuse first.
KM195
CAUTION
Always replace a blown fuse with
a fuse of the same type and rat-
ing. If the new fuse blows after a
short period of use, consult an
authorized Arctic Cat ATV dealer
immediately.

Storage Compartment/Tools

A basic tool kit is provided with the ATV. It is located under the seat.
Maintain the tool kit with the ATV at all times.
KM854A
KM863
49