General Information; Atv Identification Numbers; Ignition Switch Key; Control Locations And Functions - Arctic Cat 150 2013 Operator's Manual

General Information

ATV Identification Numbers

The Arctic Cat ATV has two identifi-
cation numbers: Vehicle Identifica-
tion Number (VIN) and Engine
Serial Number (ESN).
The VIN is located on the horizontal
frame bar.
The ESN is located on the left-side of
the engine crankcase near the lower
front.
These numbers are required by the
dealer to complete warranty claims
properly. No warranty will be
allowed by Arctic Cat if the VIN or
ESN is removed or mutilated in any
way.
Always provide the ATV name, VIN,
and ESN when contacting an authorized Arctic Cat ATV dealer for
parts, service, accessories, or warranty. If a complete engine must be
replaced, ask the dealer to notify Arctic Cat for correct registration
information.

Ignition Switch Key

Two keys come with the ATV. Keep the
spare key in a safe place.
34
Control Locations and
Functions
Ignition Switch
The ignition switch has three positions.
OFF position — All electrical circuits
are off. The engine will not start. The
key can be removed in this position.
ON position — The ignition circuit is complete, the engine can run.
The key cannot be removed in this position.
KM857A
LIGHTS position — The ignition circuit is complete and the parking
lights and taillights are on. The headlight switch is active and the key
cannot be removed in this position.
Leaving the ignition switch in the ON or LIGHTS position for a
long period of time when the engine is not running may cause the
battery to discharge. Always leave the ignition switch in the OFF
position when engine is not running.
KM849A
Hand Brakes
The hand brakes should be applied whenever a braking situation is
needed.
Apply the brakes by compressing the brake levers toward the handlebar.
ATV-0055A
CAUTION
KM864