Wheels; Bulb Replacement - Arctic Cat 150 2013 Operator's Manual

CAUTION
When breaking the tire bead loose from the wheel, be extremely
careful not to damage the inner wheel surface or the tire bead.
! WARNING
Use only Arctic Cat approved tires when replacing tires. Fail-
ure to do so could result in unstable ATV operation.
Tubeless Tire Repair
Should a leak or flat tire occur due to a puncture, the tire may be
repaired using a plug-type repair. If the damage is from a cut or if the
puncture cannot be repaired using a plug, the tire must be replaced.
When operating the ATV in areas where transportation or service
facilities are not readily available, it is strongly recommended to carry
a plug-type repair kit and a tire pump along.

Wheels

1. Park the ATV on level ground and engage the brake lever lock.
2. Loosen the wheel nuts on the wheel to be removed.
3. Elevate the ATV.
4. Remove the wheel nuts.
5. Remove the wheel.
6. Install the wheel and install wheel nuts.
7. Tighten in a crisscross pattern to 30 ft-lb.
8. Remove the jack.

Bulb Replacement

The wattage rating of the bulb is shown in the chart. When replacing a
burned bulb, always use the same wattage rating.
Headlights
Parking Lights
Brakelights/Taillights
CAUTION
Use only specified bulb indicated in the chart as replacement bulb.

NOTE: The bulb portion of the headlight is fragile. HANDLE
WITH CARE. When replacing the headlight bulb, do not touch
the glass portion of the bulb. If the glass is touched, it must
be cleaned with a dry cloth before installing. Skin oil residue
on the bulb will shorten the life of the bulb.
To replace the headlight bulb, use the following procedure.
12V/35W/35W (2)
12V/5W (2)
12V/21W/5W (2)
51