Camera Control Window; Using The Camera Control Tool - JAI CM-030PMCL-RH User Manual

1/3” progressive scan monochrome remote head camera
Table of Contents

Advertisement

Files
When clicking the Write to File or Read from File button, the user is prompted for a file using
a standard file dialog. New files are created if they do not already exist.
Files for camera settings have the extension cam. Information about the communication port
is not stored in the files. All settings are automatically sent to the camera when a file has
been loaded (if the camera is online).
Factory and User Settings
Use the Store button to store the current camera settings into the user settings area in
EEPROM. Current camera settings are not saved when the camera is turned off. To save
current camera settings you have to save them on the available user areas.
Use the Load button to restore previously saved camera settings from either the Factory or
the User EEPROM area.
Write All Camera Data to File.
Click the "Write Camera Data" button to save all camera settings into a
text file. The information that can be saved is:
Model Name, Camera ID, User ID, Firmware Version, Current Settings,
Factory Settings and the available User Areas.
The file is formatted as shown in the picture below:
EEPROM Current Area
Click the „Get Area‟ button to read the power up settings area number.

8.4. Camera Control Window

The Camera Control Window contains the
fundamental camera setting functions.
It is possible to set the shutter mode,
Trigger mode, image format, scan format,
gain control and black setting.

8.5. Using the Camera Control Tool

Here is some practical information about the Camera Control Tool:
1. The Camera Control Tool bar is always on top of other windows.
2. When you minimize the Camera Control Tool bar all open windows will close.
3. It is possible to work with the Camera Control Tool when the camera is online and
when the camera is offline.
4. The newer JAI cameras always start up with the last used user area (but for some old
models it will start up with the last saved user area.)
CM-030PMCL-RH
30

Advertisement

Table of Contents
loading

Table of Contents