Table of Contents
Advertisement
Appendix C DOC® 2000 Installation
C.1 DiskOnChip®2000 Quick Installation Guide
C.1.1 DiskOnChip® 2000 installation instructions
1.
Make sure the target platform is powered OFF.
2.
Plug the DiskOnChip® 2000 device into its socket. Verify the
direction is correct (pin 1 of the DiskOnChip 2000 is aligned with
pin 1 of the socket).
3.
Power up the system.
4.
During power up you may observe the messages displayed by the
DiskOnChip 2000 when its drivers are automatically loaded into
the system's memory.
5.
At this stage the DiskOnChip 2000 can be accessed as any disk in
the system.
6.
If the DiskOnChip 2000 is the only disk in the system, it will
appear as the first disk (drive C: in DOS).
7.
If there are more disks besides the DiskOnChip 2000, the DiskOn-
Chip 2000 will appear by default as the last drive, unless it was pro-
grammed as the first drive. (Please refer to the DiskOnChip 2000
utilities user manual.)
8.
If you want the DiskOnChip 2000 to be bootable:
a.
using
b.
tems
using
DATE C /S: DOC121.EXB(set as d:)
POS-761F User's Manual
Guide
Copy the operating system files into the DiskOnChip by
the standard DOS command (for example: sys d:).
The DiskOnChip 2000 should be the only disk in the sys-
or would be configured as the first disk in the system (c:)
the DUPDATE utility.
DUPDATE D /S: DOC121.EXB /FIRST(set as c:)DUP-
138
Advertisement
Table of Contents
