Returning The Flat Panel Monitor - Silicon Graphics 1600SW Owner's Manual

Returning the Flat Panel Monitor

If your service provider instructs you to return the flat panel monitor,
follow the instructions below.
Note: If you are instructed to return the adapter board for your
flat panel monitor, check in the documentation that came
with the adapter board for removal and return
instructions.
1. Turn off your computer. Disconnect the power cable from the rear
of the flat panel monitor.
2. Disconnect the interface cable from the computer.
3. Replace the original protective plastic film over the monitor's
screen. Be sure the plastic film is clean and free of grit that may
damage the monitor's screen.
4. If your service provider instructs you to do so, remove the flat
panel monitor from its base. See "Removing the Flat Panel
Monitor From Its Base and Replacing It on the Base" on
page EN-7.
5. If you receive a replacement flat panel monitor, use that shipping
carton and packing materials to return the faulty monitor, or use
the flat panel monitor's original shipping carton and packing
materials.
Troubleshooting EN-21