No Image On The Flat Panel Monitor - Silicon Graphics 1600SW Owner's Manual

No Image on the Flat Panel Monitor

• Check to see if the flat panel monitor and computer are turned
on. (Press the power button on the front of the monitor.) The flat
panel monitor takes about a minute to warm up to full
brightness.
• Check the color of the LED on the front of the flat panel monitor
and look for a possible cause in Table 2-1.
• Make sure that the DC power cable is connected securely to the
flat panel monitor.
• Check that the correct AC power cable for your country (110 V or
220 V) is connected securely to the AC adapter and to a working
wall outlet or power strip. (See "Connecting the Cables" on
page EN-4.)
• Check that the interface cable is connected securely to the flat
panel monitor's adapter's connector on the computer. (See
"Connecting the Cables" on page EN-4.)
• If you recently installed the flat panel monitor's adapter board in
your computer, the board may not be installed correctly, or the
software may not be installed. Follow the instructions in the
installation manual that came with the board to make sure you
have installed the hardware and software correctly. Also, you
may wish to reseat the adapter board in the computer to make
sure that the board is making proper electrical contact.
• If the flat panel monitor was not connected to the computer via
the interface cable when the computer was turned on, reboot the
computer so that the correct timing table is used for the flat panel
monitor.
Troubleshooting EN-15