Troubleshooting Tips - Silicon Graphics 1600SW Owner's Manual

EN-14 Chapter 2
Table 2-1 (continued)
LED State Monitor State
Blinking yellow 1
Solid green 2
Solid yellow 3

Troubleshooting Tips

Subsequent sections offer more detailed troubleshooting information.
In addition, check any documents that come with your monitor's
adapter board.
If the problem persists after following the suggestions below, call your
service provider.
Explanation of LED States
Possible Causes and Solutions
Screen Software is not configured
is off. correctly. See the manual that
comes with the monitor's adapter
board for your computer.
An interface cable might be loose
or disconnected.
The adapter board (in systems so
equipped) may be loose or
otherwise not installed properly.
Screen and The flat panel is operating
backlighting normally.
are on.
System System Power Save mode has
Power Save turned off the screen because there
is on and has been no keyboard or mouse
screen is off. action for a while. Move the mouse
or touch the keyboard to enable the
monitor.