Unpacking The Flat Panel Monitor - Silicon Graphics 1600SW Owner's Manual

EN-2 Chapter 1
a PCI or AGP board and have a CRT monitor connected to your
system, you may need to use your system's setup utility to select
a primary (default) monitor.
• If your system can use separate, dual PCI or AGP cards, then you
may be able to use the flat panel monitor and a CRT monitor at
the same time. See your system's owner's guide and any
documentation provided with the adapter board for more
information.

Unpacking the Flat Panel Monitor

To unpack and set up the flat panel monitor, follow these steps.
(Unpacking instructions are also printed on the shipping box.) Save
the original shipping materials in case you need to return the monitor
for service.
1. Open the box, remove the top carton and AC power cord, and set
both aside.
2. Using the lifting strap that is packed around the monitor,
carefully lift the monitor, its base, and some protective foam
pieces from the box. Place this assembly on a flat surface.
3. Remove the top foam support, then lift the monitor from the
bottom foam piece and remove the plastic bag.
4. Remove the protective film from the screen by peeling it away
slowly from one corner, keeping the peeled off portion as close to
the monitor's surface as possible. Be careful not to get
fingerprints on the exposed coated glass surface. Keep this
protective film in case you need to return the monitor for service.
The screen is made of glass coated with optical
Caution:
films and is the most expensive component in the
monitor. A blow from a sharp instrument such as
a pen can scratch the surface or break the glass.