Tv Signal Amplifier; Cable Tv Connection - Winnebago Sunstar 26HE User Manual

SECTION 8 -
ENTERTAINMENT
NOTE: LED lights will illuminate from left to
right. All LED lights may not illuminate,
depending on signal strength.
5. Rotate Attenuator Dial COUNTER-
CLOCKWISE until the last illuminated LED
light flickers.
6. Rotate antenna to illuminate the last flickering
LED light.
7. Repeat Steps 5 and 6 to pinpoint signal
reception.
NOTE: Refer to television manufacturer's
instructions to scan for available
channels.
Further Information
See the antenna manufacturer's user guide
provided in your InfoCase for complete operating
and maintenance information.

TV SIGNAL AMPLIFIER

The TV Signal Amplifier is built into the
antenna and can be turned on or off with a power
switch.
An indicator light will illuminate when the
switch is on and the signal amplifier is active.
TV Signal Amplifier Power Switch
(Located in an overhead cabinet or mounted
on a wall near the TV)
-Typical View
8-2

CABLE TV CONNECTION

input connection (located in the water service
center) for your convenience.
• Power
Switch
Your coach is equipped with a cable television
Cable TV Connection
(Located in water service center)
-Typical installation shown