Checking Hydraulic Oil Level - Winnebago Sunstar 26HE User Manual

SECTION 10 -
SLIDEOUT ROOMS AND LEVELING
briefly and a chime will sound when the ignition
key is turned to the On or Run positions if the
jacks are down.
"Jacks Down" Light
(Located on dash)
-Typical View
NOTICE
• Do not try to drive vehicle unless
"TRAVEL" light is glowing with ignition
switch on.
• Do not try to drive the vehicle until the
air suspension system has built up
sufficient pressure if you have used
the coach leveling system or have
used the DUMP button to manually
exhaust the air suspension system.
• Do not rely only upon the warning
lights to indicate when jacks are up. It
is the owner's responsibility to check
that all jacks are up before moving the
coach.
NOTE: If the Leveling Jacks should fail to
retract, see "Troubleshooting" and
emergency operation instructions in the
Leveling System Operation Guide
provided in your InfoCase.
In The Event Of Accidental Jack
Extension
1. Bring the vehicle to a safe and complete stop
as soon as possible.
10-8
2. Turn the Leveling System Power switch ON,
use the arrow "Down" button and select "Auto
Retract", and press Enter.
3. Visually inspect the vehicle undercarriage for
any problems.
4. See the Leveling System Operation Guide
supplied in your InfoCase for troubleshooting
instructions or operating the Leveling System
if jacks fail to retract or any other functions
fail.
Further Information
See the manufacturer's operation guide
provided in your InfoCase for complete operating
instructions, safety precautions, and
troubleshooting tips.
CHECKING HYDRAULIC OIL
LEVEL
See the Leveling System Operation Guide
provided in your InfoCase for complete
maintenance instructions and information.
All maintenance should be done as part of the
normal servicing of the coach.
The hydraulic oil level should be checked
when the vehicle is first purchased and after any
extended storage. During regular vehicle use the
hydraulic fluid level should be checked once a
month. If an oil leak develops, the hydraulic oil
level needs to be checked frequently until repairs
can be completed.
The hydraulic pump/reservoir is located
behind the driver side front tire. In certain
models, an access panel must be removed to
access the pump/reservoir.
NOTE: Leveling jacks must be in the retracted
(UP) position to get an accurate oil level.
The hydraulic oil level is checked visually by
inspecting the hydraulic oil reservoir. Always
keep the hydraulic oil level full (to the lip of the
breather cap).
NOTE: Always clean away any dirt and debris
from the top of the reservoir before
removing the breather cap to avoid entry