Oce CS7400 Series User Manual page 69

Menus
• Maximal with Skew Reporting — same as Maximal, but
also reports the amount of skew on the control panel
Choose Minimal for fastest throughput, Maximal for greatest
precision and skew detection when printing edge-to-edge.
• Quality Check — determines how AutoTune errors are
handled (see "AutoTune" on page 4-4).
• Sleep Wait Time — sets the period of time to wait for a print
job before going into Sleep mode (see page 3-5).
• Expert/Novice Messages — Novice mode presents an
ATTN (Attention) key with Warnings (alerts that do not pro-
hibit printing) and Actions (conditions that require user inter-
vention before printing can proceed). Expert mode presents
Actions only, presents fewer "press Proceed" prompts after
an Action has been addressed. The default is Novice mode.
When in Expert mode, active Warnings and Actions can be
displayed by selecting Warnings & Actions from the menu,
since Warnings will not cause the ATTN key to appear in
Expert mode. See "Overview" on page 3-2 for further infor-
mation about Actions and Warnings.
• Localization — sets English or Metric units of measure,
time and date formats, and vacuum pressure units, for data
displayed by the control panel.
• Automatic Eject (cut sheet printing only) — when enabled,
the sheet is automatically ejected at the end of the print job.
When disabled, the next job(s) will print on the same sheet
until there is not enough room to complete the next job.
• Low Ink Warning — defines the amount of ink remaining in
the ink box supply at which the printer will display a "low ink"
message on the control panel.
• UV Lamps Idle Time — sets the amount of time the lamps
will stay on after printing before they are automatically turned
off by the printer. The idle time can be set from 1 to 8 min-
utes. Increase the idle time if you are printing several jobs
and waiting for the lamps to warm up between prints.
Decrease the idle time if printing single jobs.
• Printer Name — displays a keypad to change the printer
name displayed on the control panel and RIP.
• Restore All Defaults — restores all Printer Configuration
settings to their factory default values, and zeroes all regis-
tration data. After running this option, all printhead calibra-
3-11