Oce CS7400 Series User Manual page 42

2-12
10. Slide the adjustable media fence against the right side of the
media. Then lock it in place.
At this point you can also adjust the speed of the vacuum
fans, or switch them on or off. If the sheet is warped or not
being held down, increase the vacuum fans or raise the
pinch rollers.
11. If the edge of the media you are using is directly below a
pinch roller, raise that pinch roller by pushing it up and then
pushing the latch toward the rail to engage it (see Fig. 2-5
below). To lower the pinch roller, push it up and the latch will
disengage, then lower the roller to the platen.
Latch
Pinch roller assemblies
12. Move the media edge holders (for roll-fed media) out of the
media path, and make sure that the output door is closed.
13. Press the  (Proceed) key on the control panel, or the
Load/Unload switch on the back of the printer to the Load
position, or the optional foot switch (if installed). This causes
the printer to:
• Measure the media thickness
• Measure the media width
• Find the leading edge of the media
Media thickness sensor
Fig. 2-5. Pinch rollers
Load and Print on Rigid Media