Oce CS7400 Series User Manual page 62

3-4
• Job Tracking Log — list of the last ten print jobs, with
diagnostic information.
• Media Tracking Log — the amount of sheet fed and roll
fed media printed since the reset button on this screen
was pressed.
3. Ink levels — numeric and graphic ink levels; line marks "low
ink" level. Press here to display detailed ink status.
4. UV lamps status (R=right side, L=left side) — black=off,
yellow=on, blinking=warming up. Press here for detailed
lamp status and controls. Whenever the UV lamps are
warming up or cooling down, the time remaining until they
are finished is displayed. The lamp icons also indicate the
position of the shutter aperture (see page 2-5).
5. Cover — open or closed.
6. Langauge selector — if installed, switches the control panel
language from English to an alternate language.
7. Print prime bars — fires all jets by drawing a set of lines
called prime bars. This is a good way to inspect and prepare
the jets for printing after they have been idle (see "Print
Prime Bars" on page 3-9). You can also print a similar pat-
tern called Print Jet-Out Lines, which shows which jets have
been detected and replaced by AutoJet (see page 3-12 for
details).
8. Purge printheads — purges the printheads to help recover
missing jets.
9. Print mode — sets print quality mode. See "Configure Print-
ing" on page 2-2 for instructions.
10. Calibrate — displays the Calibrate Printer menu.
11. Settings — displays the Printer Settings menu.
12. Tools — displays the Tools menu.
13. Move media forward/backward — press the  key to
advance the media forward. When you press and hold the 
key, the media moves faster. Press the  key to reverse the
media back onto the supply spool. When you press and hold
the  key, the media moves faster. (The same functionality
Front Page