Oce CS7400 Series User Manual page 53

Printing Tips
4. Using a 5 mm hex wrench, loosen the two set screws
(shown below) that secure the vertical position of the move-
able fence.
Fig. 2-13. Height adjustment screws
5. Place a long, flat, thin metal ruler on top of one column of
table rollers.
6. Place the moveable fence arm on top of the metal ruler.
7. Press down on the arm until moveable arm is flat against the
ruler.
8. Tighten both set screws.
The arm may move while tightening the set screws. Re-
check the position after tightening.
9. Push the moveable arm back and forth across the width of
the table to make sure that the arm does not contact the
rollers.
Tip To prevent thin flexible media from slipping under
the fence, the fence can be lowered to just under
the top surface of the rollers. In this case, use
extreme care when moving the fence across the
width of the media, to avoid striking the rollers.
2-23