Oce CS7400 Series User Manual page 43

Load and Print on Rigid Media
After briefly displaying the measured width of the media, the
control panel displays the media and margin measurements
(see Fig. 2-6):
• To change the margins, press the Margin Settings key.
Note The minimum Trailing Margin is 6 inches (15.2 cm),
to enable the pinch rollers to advance the media.
Fig. 2-6. Rigid sheet measurements
14. Press the  (Proceed) key.
The control panel displays the message, "Media loaded suc-
cessfully," and asks whether to save the Media Feed Num-
ber (MFN) for the current media type.
• To load the new MFN, press the
• To discard the new MFN and used the previously-saved
MFN, press the  (No) key.
• To perform a media feed calibration or enter a different
MFN, press the Calibrate Media Feed key (For
instructions, see "Media Feed Calibration" on page 4-9.)
The Front Page screen appears.
15. Press the Go Online key.
(Yes) key.
2-13