Paper Transport; Vacuum Transport Belt Replacement - Xerox 5915 Service Manual

4-12
3.1.1 Vacuum Transport Belt
Replacement
Removal
1. Power off the machine and disconnect the
Power Plug.
2. Open the Front Cover and then the machine.
3. Remove the Drum Unit and place a black
bag over it .................................... (5.1.1)
4. Remove the Rear Upper Cover.
5. Remove the TC/DTC Assembly.
6. (Fig. 1): Remove the Main Switch Cover.
. Remove Screw.
. Remove Main Switch Cover.
(Fig. 1)
7. (Fig. 2): Remove AC DRIVE PWB.
. Remove Screw.
. Remove AC Drive PWB Cover.
. Disconnect the plug and remove AC Drive
PWB,
3
º ó Ã æ
2
1
(Fig. 2)
Section 4 Disassembly/Assembly/Adjustment
8. (Fig. 3): Remove the Vacuum Transport
Assembly.
. Remove Screw.
. Remove Vacuum Transport Assy.
NOTE: • Pushing the rear pin with a screw
driver as shown in Fig. 3 makes it
easier to remove.
(Fig. 3)
9. (Fig. 4): Remove the Transport Belt.
. Remove E Clip and then Bearing.
. Slide Shaft.
. Remove Transport Belt.
(Fig. 4)

2. Paper Transport

Installation
1. Perform the installation in the reverse order of
removal.
NOTE: • (Fig. 5): Pay attention to the Belt
direction.
(Fig. 5)