Xerox 5915 Service Manual page 120

6-10
6.6.6 Setting start mode
The start mode can be set and changed as required.
Procedure
1. Press Custom Presets.
Note Custom Presets is cleared if no button is pressed within 60 seconds.
2. Enter 86, using the Numeric Keyboard and the start mode is set.
3. Press Start, and the current value of the program code (0 is factory-set) will be displayed in the Copy
Quantity display.
4. Enter one of the numbers 0,1, which represent respectively as follows:
0-- No-password mode. The machine will enter directly the ready to copy state when it is turned on.
1-- Single-password mode. The information presenting state Id
machine is turned on, and a password has to be entered before copies can be made.
5. When the selected value is displayed in the Quantity display, press Start for the setting to be memorized.
There is no display in the Copy Quantity display, indicating the entered code is correct. If a wrong code is
entered and "Er" displayed in the Quantity display, press Start/Clear and re-enter a correct code.
6. Press Custom Presets to make the machine exit the customizing state and return to the normal copy
state.
will be displayed when the
Section 6 GENERAL
6.6 Program Setting