Lead Edge Registration Adjustment - Xerox 5915 Service Manual

. (Fig. 3): Remove One-Way Clutch and
Gear. (Spring disengages together.)
. Remove E Clip and then Bearing.
(Fig. 3)
. (Fig. 4): Turn over Registration Assy.
. Push in Registration Gate Solenoid plunger
with your finger.
. Remove Registration Roller (with plunger
pushed in).
(Fig. 4)
4-11
Installation
1. Perform the installation in the reverse order of
the removal.
2.7.6 Lead Edge Registration
Adjustment
Purpose To properly align the copy image on
the Drum with the lead edge of
paper.
Check
1. In 100% Mode, align Test Chart(499T247 or
248) with Regi-Guide and make a copy.
2. (Fig. 1): Check that there is 10±1.6mm from
the copy's lead edge to the reference line.
(Fig. 1)
Adjustment
• Fast Paper Feed(The distance is more than
10±1.6mm from the copy's lead edge to the
reference line.)
1. Key in Diag. [20-1].
2. Increase data.
NOTE: • Changing the data by 1 will change the
distance by 0.2584mm.
• Slow Paper Feed(The distance is less than 10+
1.6mm from the copy's lead edge to the
reference line.)
1. Key in Diag. [20-1].
2. Decrease data.
NOTE: • Changing the data by 1 will change the
distance by 0.2584mm.
3. Make a copy and check it.
4. Perform the ISIL Copy Edge Erase Amount
Adjustment ......................................... (5.1.6)
Section 4 Disassembly/Assembly/Adjustment
2. Paper Handling