Heater Rod Replacement - Xerox 5915 Service Manual

8.2.1 Heater Rod Replacement

NOTE: a. Take great care in handling the Heater
Rod glass tube. It is fragile.
b. Do not touch the Heater Rod glass
tube with your bare hand(s). If you
touch it, wipe it with Drum Cleaner.
Removal
1. WARNING: Power off the machine and
disconnect the power cord.
WARNING
Fuser surfaces can be hot. Fuser lubricant can
cause discomfort to eyes. Do not allow fuser
lubricant to touch eyes.
2. Open the Front Cover and then the machine.
3. Remove the Drum Unit and place a black
bag over it. ................................... (5.1.1)
4. Remove the Left/Rear Upper Covers.
5. (Fig. 1): Remove the Main Switch Cover.
. Remove Screw.
. Remove Main Switch Cover.
(Fig. 1)
4-29
6. Disconnect P/J's 12, & 13 from the Heater
Rod.
7. (Fig. 2): Remove the Front/Rear Heater Rod
Covers each.
. Loosen Screw.
. Remove Front/Rear Heater Rod Covers.
(Fig. 2)
8. (Fig. 3): Remove the Heater Rod.
. Loosen Screw.
. Remove Front Support Bracket.
. Remove Heater Rod.
NOTE: • Hold the insulator and take out the
Heater Rod.
(Fig. 3)
Section 4 Disassembly/Assembly/Adjustment
Installation
1. Perform the installation in the reverse order of
removal.
NOTE: • Determine which way(front or rear) the
Heater faces by the color of the
connector.
8. Fuser