Table of Contents
Advertisement
This function allows you to run a special demo-test sequences without an external controller, which will show you
some possibilities of using VISION 250. Press [+] and [-] keys to select the "Mod1" or "Mod2" sequences. The
"Mod1" is suitable for projections on the wall, ceiling or ground without any mirror-movement, the "Mod2" uses
all VISION 250 functions and therefore is good for a complete introduction of the fixture.
Press [Enter] key to run reset. This option enables the VISION 250 to index all effects (functions) and return to
their standard positions.
8.2 SPEC -Special functions
Use the [+] and [-] keys to browse through the special functions and select the one by pressing [Enter].
This function allows you to control manually the channel functions of the fixture. Use the [+] and [-] keys to select
desired function and press [Enter] to adjust the effect or [Menu] to cancel and return to the menu.
Demo sequences
Reset Function
Manual control of effects
15
Advertisement
Table of Contents
