Rotating Gobo Wheel; Effect Wheel; 3-Facet Rotating Prism; Focus - Elation VISION 250 User Manual

7.4 Rotating gobo wheel

1 metal gobo, 4 glass gobos and 1 dichroic gobo rotating in both dirrections, indexable, rotating gobo wheel cont.
rotation slow to fast.The rotating gobos are interchangeable.

7.5 Effect wheel

This wheel has both hot and cold colour temperature filters (3200 K and 5600 K). Total numbers of colour
combinations are 36. Also wash light and UV effect are provided by the special effect wheel.

7.6 3-facet rotating prism

3-facet prism rotating in both directions at different speed is situated at the special effect wheel.

7.7 Focus

Motorized focus enables the beam to be focused anywhere on stage.

7.8 Dimmer / Shutter / Strobe

Smooth 0 - 100 % dimming is provided by the combined mechanical dimmer / shutter unit. This unit may also be
used for strobe effect (1 - 10 flashes per second)

7.9 Fan

The VISION 250 is cooled by an axial fan situated at the bottom of the fixture. The speed of the fan (of course the
noice) can be continuously reduced if very quiet performance is required.
By the control board using the "FAnS" function you can choose 4 types of fan speed operating modes:
1. "HIGH" - high (max) speed of fan
The cooling fan works on max. speed (max. cooling)
2. "reG" - continuous controlling of the fan speed
the fan automatically raises its speed in order to control inside temperature of the lighting, if the
temperature inside increases about certain level (the low fan speed reduces the cooling of the lighting).
This cycle can repeat several times until the temperature inside is on suitable level.
3. "LoOF" - low speed/Switch Off the lamp operating
the fan keeps the adjusted low speed until the temperature exceeds max. inside temp. Then the VISION
250 automatically switch Off the lamp.
4. "loHi" - low/high speed of the fan operating
the fan keeps the adjusted low speed until the temperature exceeds max. inside temp. of the fixture,
then the VISION 250 automatically switch from low to high the fan speed.

8. Control Board

The control board situated on the front panel of the VISION 250 offers several features. You can simply set the
lighting address, read the number of lamp or unit hours, switch On and Off the lamp, run test show, make a reset
and also use special functions for manual, demo and service purposes.
The main menu is accessed by pressing the [Menu] key - press this one so many times until the display shows
message "A001" (with actually stored address). Browse through the menu by the pressing [+] and [-] keys - the
display shows step by step these messages: A001, rPAn, rTilt, 16br, Lati, Poti, LAMP, dEMO, rESE, SPEC.
Press [Enter] if you wish to select one of them. The functions provided are described in the following sections and
the function hierarchy is shown below.
13