Table of Contents
Advertisement
1. Calibration via the control board
Press [Enter] and the [+] and [-] keys in order to display the following messages: "Colo, EFEC, rGob, rotG," for
very smooth function calibration. Select one of them, press [Enter] and use the [+] and [-] keys in order to adjust
their right value from 0 to 255. Then press [Enter] to confirm or [Menu] to cancel and return to the menu. This can
be repeated for each calibration parameter if it is required. When the calibration is finished, it is necessary to use
the "ArES" function in order to write the calibration values to the memory (EPROM) and to make a reset in order
to check the newly adjusted positions of the colour, gobo and effect wheels. When the reset of the fixture is
finished, the display will show the "FCAL" message. Press [Enter] to repeat the calibration or [Menu] to return to
the "AdJ" menu.
2. Calibration via the external controller
Press [Enter] and the [+] and [-] keys in order to display the following messages: "Colo,EFEC, rGob, rotG," -
calibration parameters. Select one of them and press [Enter].
Now you can calibrate the the colour, gobo and effect wheel by your controller. The DMX calibration protocol is
described in the table.
DMX Calibration protocol:
After having calibrated required functions press [Enter] to confirm (or [Menu] to cancel and return to the menu
without reset by the "ArES" function) and use the "ArES" function in order to write the calibration values to the
memory (EEPROM) and to make a reset in order to check the new adjusted positions of the colour,effect and
rot.gobo wheels and gobo indexing .
19
Advertisement
Table of Contents
