Table of Contents
Advertisement
5. attach the snap disc bracket to the stud located under
the left side of the appliance using the 10-32 nut also
located in the appliance component bag. tighten until
snug using the 3/8 in. wrench. See Figure 8.7 and Figure
8.8.
Figure 8.7 Attach Snap Disc Bracket
Figure 8.8 Mount Speed Control Using Pal Nut
JUMPER
(BLUE)
Figure 8.9 Fan wiring Diagram
JUNCTION BOX
39
Heat & Glo • TIARAP-BK-IPI, TIARAP-BR-IPI, TIARAP-CES-IPI Installation Manual • 2344-980_R4 • 11/14
6. Install the speed control (rheostat). the speed control
mounts to the right rear corner of the component tray.
Insert the stem of the speed control through the hole
located on the right side of the cover. Secure with the
pal nut using an 11/16 in. (17.5 mm) wrench. Attach
the black and white wires routed under the appliance
indicated in Figure 8.9 (wiring diagram), to the variable
speed switch wires. Use the blue jumper wire provided in
the appliance component bag to make the connection on
junction box terminals as shown in Figure 8.9. Push the
speed control knob onto the stem. Secure any extra wire
up and out of the way using the zip tie provided.
7. Plug the fan into the receptacle labeled "FaN" on the
junction box. See Figure 8.9. the blower will not run
until the appliance has heated up enough to activate the
snap disc. this can take up to 15 minutes depending on
the temperature of the room. likewise, the blower will
not automatically turn off until the appliance has cooled
off enough to turn off the snap disc.
Turning the control knob to the left (counterclockwise)
until you hear an audible click will turn the blower "oFF".
Turning the control knob to the right (clockwise) until you
hear a click will turn the blower "oN". turning the con-
trol knob further to the right will reduce the speed of the
blower.
FAN
WHITE
WHITE
BLACK
VARIABLE SPEED SWITCH
BLACK
Advertisement
Table of Contents
