Table of Contents
Advertisement
Optional Fan Installation
KIT CONTENTS:
1 - Blower Mounted in housing
2 - Speed control Knob
3 - Pal Nut
4 - Ceramic Snap disk
5 - Speed Control (rheostat)
6 - wire harness (attached to Blower)
7 - 12 Screws
8 - 12 inch glass Tape
9 - 1 Zip Tie
10 - Bracket #1
11 - Thermostat Bracket
TOOLS REQUIRED: Short #2 Philips screwdriver; 11/16
in. wrench, 3/8 in. wrench.
Installation
1. open and inspect contents of the blower kit. the
contents of the kit are listed above and shown below in
Figure 8.3. If any of the parts are missing or damaged,
please contact your dealer for replacements.
NOTE: Not all parts will be used for this install.
10
Figure 8.3 Fan Kit Contents
2. lift off the appliance top and place it on a flat surface, with
the porcelain side up to prevent damage. remove the
back shield by removing the two screws along the top of
the shield. See Figure 8.4. Place the blower on the floor
behind the appliance and route the ends of the wiring
harness through the rubber grommet on the underside.
3. holding the blower in place, attach it to the appliance with
four of the screws provided. See Figure 8.5.
38
Heat & Glo • TIARAP-BK-IPI, TIARAP-BR-IPI, TIARAP-CES-IPI Installation Manual • 2344-980_R4 • 11/14
Figure 8.4 Remove Back Shield
Figure 8.5 Attach Blower with Four Screws
4. Install the snap disc. a snap disc bracket is located in
NOTE: the mounting flange is on top of the bracket.
11
Figure 8.6 Install Snap Disc
the appliance's component bag. Bend the two spade
teminals on the snap disc from a horizontal to a vertical
position. Insert the snap disc through the hole in the
snap disc bracket and attach the two white wires from
the wiring harness to the snap disc. See Figure 8.6.
SNAP DISC
SNAP DISC
BRACKET
SPADE
TERMINALS
Advertisement
Table of Contents
