Table of Contents
Advertisement
D. Install the Log Assembly
Log Set Assembly: LOGS-GARNET
CAUTION: Logs are fragile, handle with care. Log #1 (7016-172): gently remove top of unit and set aside. remove cast
face by sliding straight up and set aside. Remove the glass by removing the three Phillips head fasteners at the top of the
glass frame assembly. lean glass frame forward and lift out. Place the notch in the Rear log over the pilot assembly. Push
the log all the way to the rear of the firebox and center the log from left to right. See Figure 10.3.
LOG #1
(7016-172)
LOCATING PIN
LOG #2
(7016-171)
Figure 10.3.
Log #2 (7016-171): align hole on bottom of log #2 with locating pin on log #1. Position bottom of log #2 into notch on
left front of burner. See Figure 10.4.
Log #3 (7016-170): align hole on bottom of log #3 with locating pin on log #2. Position bottom of log #3 into the notch on
the right front of burner. See Figure 10.5.
LOCATING PIN
Figure 10.4
43
Heat & Glo • TIARAP-BK-IPI, TIARAP-BR-IPI, TIARAP-CES-IPI Installation Manual • 2344-980_R4 • 11/14
LOCATING PIN
LOG #3
(7016-170)
LOCATING PIN
Figure 10.4
Figure 10.5
Advertisement
Table of Contents
