Consumable Materials - Beechcraft Debonair 35-33 Pilot Operating Handbook

Section VIII BEECHCRAFT
Debonair33
Handling, Serv - Maint
trim tab pushrod end fittings with BRAYCO
300, CRC 3 -36, LPS No. 1, or WD-40. (See
Consumable Materials.)
CAUTION
When cleaning wheel weil areas with solvent,
especially if high -pressure equipment is used,
exercise care to avoid washing away grease
from landing gear components. After washing
the wheel weil areas with solvent, lubricate all
lubrication points, or premature wear may
result.
Do not apply wax or polish to uncured painted
surfaces. Waxes and polishes seal the paint
from the air and prevent curing. Alkyd enamel
(sometimes called "automotive enamel"),
acrylic enamel. lacquer, and dope finishes
require a curing period of approximately 90
days; acrylic urethane, polyester urethane, and
epoxy finishes eure in seven days at 75°F.
Wash uncured painted surfaces with cold or
lukewarm water and a MILD NON -
DETERGENT SOAP. Any rubbing of the surface
should be done gently and held to a minimum
to avoid cracking the paint film .
Prior to cleaning , cover the wheels, making certain the
brake discs are covered. Attach the pitot cover securely,
and plug or mask off all other openings. Be particularly
careful to mask off all static air buttons before washing or
waxing . Use special care to avoid removing lubricant from
lubricated areas. When using high-pressure washing
equipment, keep the stream or spray clear of wheel
bearings, propeller hub bearings, etc., and openings such
8-24
April 1982