Automatic Technology SecuraLift GDO-7V1 Owner's Installation Instructions Manual page 5

Important safety instructions
to water or rain. It is not to be immersed in water or sprayed directly by a hose or other water carrying device.
The garage door must be well balanced. Sticking or binding doors must be repaired by a qualified garage
door installer prior to installation of the opener.
Frequently examine the installation, in particular cables, springs and mountings for signs of wear,
DO NOT
damage or imbalance. use if repair or adjustment is needed since a fault in the installation
DO NOT
or an incorrectly balanced door may cause injury. attempt to repair the door yourself as
hardware is under extreme tension.
Remove or disengage all garage door locks and mechanisms prior to installation of the opener.
Connect the garage door opener to a properly earthed general purpose 240V mains power
outlet installed by a qualified electrical contractor.
Disconnect the power cord from mains power before making any repairs or removing
covers. Only experienced service personnel should remove covers from the garage
door opener.
When using auto close mode, a photo electric beam must be fitted correctly
and tested for operation at regular intervals. extreme caution is recommended
when using auto close mode. all safety rules must be followed.
In order for the garage door opener to sense an object obstructing the
door way, some force must be exerted on the object. As a result the
object, door and/or person may suffer damage or injury.
If the power supply cord is damaged, it must be replaced by an ATA
service agent or suitably qualified person.
Make sure that the door is fully open before driving in or out of
the garage and fully closed before leaving the driveway.
Make sure that remote controls are kept out of reach of
children.
Install the wall switch or wall mounted
transmitter in a location where it is out of
reach of children and the garage door is
visible.
Owner Installation Instructions GDO-7V1 SecuraLift® 5