Table of Contents
Advertisement
• Signal Meter
Power Switch
• Rotational Knob
• Release
Button
Digital Antenna Signal Meter
(Located on ceiling)
3. Rotate the Attenuator Dial fully
CLOCKWISE.
4. Press Release Button on the Rotational Knob
and rotate antenna (until maximum number of
LED lights illuminate on the Signal Meter).
NOTE: LED lights will illuminate from left to
right. All LED lights may not illuminate,
depending on signal strength.
5. Rotate Attenuator Dial COUNTER-
CLOCKWISE until the last illuminated LED
light flickers.
6. Rotate antenna to illuminate the last flickering
LED light.
7. Repeat Steps 5 and 6 to pinpoint signal
reception.
NOTE: Refer to television manufacturer's
instructions to scan for available
channels.
Further Information
See the antenna manufacturer's user guide
provided in your InfoCase for complete operating
and maintenance information.
• Attenuator Dial
(arrow
indicates which direction
antenna is pointing)
TV SIGNAL AMPLIFIER
The TV Signal Amplifier is built into the
antenna and can be turned on or off with a power
switch located on a switchplate in the overhead
cabinet above the entrance door.
An indicator light will illuminate when the
switch is on and the signal amplifier is active.
TV Signal Amplifier Power Switch
(Located in overhead cabinet
above entrance door)
-Typical View
SATELLITE DISH AND CABLE
TV CONNECTIONS
The portable satellite dish and cable television
input connectors are located in the shoreline
compartment.
The cable television and portable satellite dish
input lines can be routed through the hatch in the
bottom of the compartment so the door can
remain shut while connected.
SECTION 8 –
ENTERTAINMENT
• Power
Switch
8-7
Advertisement
Table of Contents
Troubleshooting
