Countertop Extension - Winnebago 2015 Tour Operator's Manual

Remote Operation
• Power
• Heater
Fireplace Remote Control
(Located inside InfoCase)
• POWER: The POWER button supplies
power to all the functions of the fireplace. The
POWER button will put the insert in standby
mode. This will turn off all functions at once
but will hold the settings in the memory. By
pressing the POWER button again the unit
will turn on at the same settings.
NOTE: Holding the POWER button on the
control panel for ten seconds will disable
the heater function.
• FLAME: Each time the flame button is
pressed, the intensity of the flame decreases.
There are (6) brightness levels you can cycle
through and the OFF setting.
• HEATER: Turns the heater function ON and
OFF.
• TIMER: Press the TIMER button to cycle
through the (10) timer settings (30 minutes, 1
Hour to 9 Hours) and the OFF setting.
• DOWNLIGHT: Pressing this button will
change the downlight ON and OFF.
Further Information
Refer to the Fireplace user guide provided in
your InfoCase for complete operating and
maintenance instructions, as well as safety
precautions.

COUNTERTOP EXTENSION

–If Equipped
(Typical view – your coach may differ)
Your coach may be equipped with a
• Flame
countertop extension that provides additional
• Timer
galley prep space.
•
(Located underneath countertop extension lip)
•
MISCELLANEOUS
To extend galley countertop extension, pull
release lever (located underneath countertop
extension lip) outward while pulling
countertop extension out.
Countertop Extension Release Lever
-Typical View
-Typical View
To retract galley countertop extension, pull
release lever outward while pushing
countertop extension back into stored
position.
SECTION 12 –
12-7