Water Pump - Winnebago 2015 Tour Operator's Manual

Water Hose Reel
- Typical View
• Press and Hold Water Hose Reel switch to
retract
NOTE:Ensure the Fresh Water valve is in
Normal position to use the water pump.
If the valve is in Tank Fill position, the
pump will run continuously without
delivering water.
Method 2 - Filling the Fresh Water
Tank Through Gravity Fill
WARNING
Potable water only.
Sanitize, flush, and drain water tank
before using.
See owner's manual for instructions,
care, and maintenance information.
Failure to maintain tank can result in
death or serious injury.
Always fill the fresh water tank at an approved
potable water filling facility or known purified
drinking water source.
The gravity tank fill port is located in the third
passenger side compartment.
Gravity Fill Port
(Located in the third passenger side
compartment)
• Insert hose into fill port and turn water supply
on.
NOTE: Be careful not to overfill the tank.
Using Tank Water (Gravity Fill)
• Turn Water pump switch ON. While the
switch is on, the water pump will
automatically supply tank water as needed.

WATER PUMP

When your coach is not connected to a city
water supply, water is supplied from the fresh
water tank by a water system demand pump. A
demand pump is designed to run only when you
are using water. When you open a faucet, the
waterline pressure drops and the pump begins to
run, and it will continue to run as long as the
faucet is open. When you close the faucet, the
line pressure backs up to the pump, and it shuts
itself off.
The pump is self-priming and will run briefly
to build up line pressure when the Water Pump
switch is first turned on. See "Initial Waterline
Priming" for instructions on using the water
system for the first time.
Water Pump Strainer
The pump is equipped with a cleanable
strainer to capture any possible tank-borne
particles that could damage pump components.
SECTION 7 –
PLUMBING
7-3