Component Video Setup - Onkyo TX-NR901 Instruction Manual

Basic Setup—Continued

Component Video Setup

This section explains how to assign the component video
inputs to input sources. You only need to change this set-
ting if you connect a video component to a component
video input other than the default assignment listed in the
following table, or if you want to output composite video
or S-Video sources from the component video output.
There are no other reasons to change these assignments.
Analog audio
Input source
input (fixed)
DVD DVD
VIDEO 1 VIDEO 1
VIDEO 2 VIDEO 2
VIDEO 3 VIDEO 3
VIDEO 4 VIDEO 4
VIDEO 5 VIDEO 5
TAPE TAPE
TUNER TUNER
PHONO PHONO
CD CD
NET AUDIO NET AUDIO
1 Press the [INPUT] button, and
then roll the scroll wheel to select
INPUT
the input source you want to
assign.
2
Press the scroll wheel, and then
press the [SETUP] button.
The main menu appears onscreen.
3
Use the Up/Down [
tons to select "2. Input Setup,"
and then press the [ENTER] but-
ENTER
ton.
The Input Setup menu appears.
ENTER
4
Component
video inputs
INPUT1
INPUT2
INPUT2
INPUT2
INPUT2
5
INPUT2
Last Valid
Last Valid
Last Valid
Last Valid
Last Valid
6
]/[ ] but-
Notes:
• If you select Last Valid, the video source remains the
same when you select another input source. For exam-
ple, if you set the VIDEO 1 input source to Last Valid,
then select the DVD input source, then select the
VIDEO 1 input source, you can watch a DVD while
listening to the audio from the component connected
to the VIDEO 1 audio inputs.
• This procedure can also be performed by using the
input selector buttons, [SETUP] button, [
[
Use the Up/Down [
tons to select "3. Video Setup,"
and then press the [ENTER] but-
ENTER
ton.
The Video Setup menu appears.
Advanced Menu
2.Input Setup
Input:DVD
ENTER
2-3.Video Setup
Input:DVD
a.Video
b.Component Video
Use the Up/Down [
tons to select "b. Component
Video," and then use the Left/
ENTER
Right [ ]/[ ] buttons to select:
INPUT1: Select if the video compo-
nent is connected to COM-
PONENT VIDEO INPUT
1.
INPUT2: Select if the video compo-
nent is connected to COM-
PONENT VIDEO INPUT
2.
VIDEO: Select this to output com-
posite and S-Video
sources from the COM-
PONENT VIDEO OUT-
PUT.
Last Valid: Select this for audio-only
components.
None: Select this if you want no
video to be output when
the input source is
selected.
Press the [SETUP] button.
The setup menu closes.
]/[ ] buttons, and [ENTER] button.
]/[ ] but-
:DVD
:INPUT1
Quit:|SETUP|
]/[ ] but-
]/[ ]/
47