Network Settings - Onkyo TX-NR901 Instruction Manual

Net-Tune—Continued
2

Network Settings

This section explains how to manually configure the
TX-NR901's network settings.
If your router's DHCP server is enabled, by default the
TX-NR901 is set use DHCP to configure itself automat-
ically (i.e., the DHCP/AUTO IP setting is On), so you
don't need to change any of the settings on the
"5. Network Setup" menu. If your router's DHCP server
is disabled, for example, you're using static IP addresses,
you'll need to configure these settings yourself. A
knowledge of Ethernet networking is essential.
What's DHCP/AutoIP?
DHCP (Dynamic Host Configuration Protocol) and Auto
IP (Automatic IP Addressing) are services used by rout-
ers, computers, the TX-NR901, and other devices to
automatically configure themselves on the network.
What's DNS?
The DNS (Domain Name System) translates domain
names into IP addresses. For example, when you enter a
domain name such as www.onkyousa.com in your Web
browser, before accessing the site, your browser uses
DNS to translate this into an IP address, in this case
63.148.251.142.
3, 4, 6
1
Press the [INPUT] button, and
INPUT
then roll the scroll wheel to select
either "IRD" or "MSRV."
2
Press the scroll wheel, and then
press the [SETUP] button.
If the Basic menu appears, use the
Down [
Menu, and press the [ENTER] button to
display the Advanced menu.
82
+
1 2 3
@. - ' / ABC DEF
TV CH
-
4 5 6
GHI JKL MNO
7 8 9
PQRS TUV WXYZ
TV VOL
+10
0 CLEAR
--/--- DIRECT TUNING
1, 2
CUSTOM
MACRO ZONE 2
1
MODE INPUT
DIMMER SLEEP
TV
INPUT
3–6
+
CH
VOL
ENTER
DISC
-
2, 7
DISPLAY MUTING
REC STEP/SLOW RANDOM
AUDIO SUBTITLE ANGLE LAST M
SURR THX All ST STEREO
] button to select Advanced
3
Use the Up/Down [
tons to select "5. Network Setup,"
and then press the [ENTER] but-
ENTER
ton.
The Network Setup menu appears.
5.Network Setup
1.IP Address
ENTER
2.Proxy Setup
3.MAC Address
4.Client Setup
→
[ENTER]Quit:[SETUP]
4
Use the Up/Down [
tons to select the menu items,
and then press the [ENTER] but-
ENTER
ton.
The IP Address menu is shown here.
ENTER
5
Use the Up/Down [
tons to select the settings, and
use the Left/Right [
ENTER
tons to set them.
To enter an IP address, select the set-
ting, and then press the [ENTER] but-
ton. The [
can then be used to enter numbers.
Press the [ENTER] button again to set
the number.
The settings are explained below.
6
When you've completed the set-
tings on any menu, press the
[RETURN] button to return to the
ENTER
"5. Network Setup" menu, use
the Up/Down [
select "Save Settings," and then
press [ENTER].
Don't turn off the TX-NR901 while the
ENTER settings are being saved (about 2 sec-
onds), otherwise they'll be lost.
7
Press the [SETUP] button.
The setup menu closes.
]/[ ] but-
Save Settings
]/[ ] but-
]/[ ] but-
]/[ ] but-
]/[ ]/[ ]/[ ] buttons
]/[ ] buttons to