Changing The Remote Controller's Transmission Signal Format (Ir/Rf); Resetting The Remote Controller - Onkyo TX-NR901 Instruction Manual

Using the Remote Controller with Other Components—Continued
Changing the Remote Controller's
Transmission Signal Format (IR/RF)
On the American and Australian models, you can set the
remote controller's transmission signal format to either
infrared (IR) or radio frequency (RF). The default setting
is IR. This function is not available on other models.
This is useful when, for example, the TX-NR901 is
installed in a rack or is not in line of sight of the remote
controller as it allows you to use a commercially avail-
able RF receiver to pick up commands from the remote
controller, which are then fed to the TX-NR901 via its IR
IN socket. For this to work, you must assign the same ID
and channel to the remote controller and RF receiver.
1
Press and hold the [CUSTOM]
CUSTOM
button for more than three sec-
onds.
The remote controller enters Custom
mode.
2 Roll the scroll wheel to select
"SETUP," and then press the
scroll wheel.
3
Roll the scroll wheel to select "IR/
RF," and then press the scroll
wheel.
4
Roll the scroll wheel to select
"IR" or "RF," and then press the
scroll wheel.
When you select "IR."
5
If you select "RF,"roll the scroll
wheel to select the same ID as
the RF receiver, and then press
the scroll wheel.
IDs 0 to 9 and A to F can be selected.
98
6
Roll the scroll wheel to select the
same channel as the RF receiver,
and then press the scroll wheel.
Channels 0 to 3 can be selected.
If the ID and channel have been set suc-
cessfully, "OK" appears on the display.

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1 Press and hold the [CUSTOM]
CUSTOM
button for more than three sec-
onds.
The remote controller enters Custom
mode.
2
Roll the scroll wheel to select
"MODE," and then press the
scroll wheel.
3
Roll the scroll wheel to select
"RESET," and then press the
scroll wheel.
4 Roll the scroll wheel to select
"YES," and then press the scroll
wheel.
The remote controller is reset to its
default settings.