Remote Setup - Onkyo TX-NR901 Instruction Manual
Hide thumbs
Also See for TX-NR901:
- Service manual (135 pages) ,
- Instruction manual (105 pages) ,
- Specification sheet (2 pages)
Table of Contents
Advertisement
Basic Setup—Continued
Remote Setup
Specifying the Location of an IR Receiver
This section explains how to specify the location when
using a commercially available IR receiver.
1
Press the scroll wheel, and then
press the [SETUP] button.
The main menu appears onscreen.
2
Use the Up/Down [
tons to select "0. Hardware
Setup," and then press the
ENTER
[ENTER] button.
The Hardware Setup menu appears.
ENTER
3
Use the Up/Down [
tons to select "3. Remote Setup,"
and then press the [ENTER] but-
ENTER
ton.
The Remote Setup menu appears.
0-3.Remote Setup
a.Position
ENTER
b.Remote ID
4
Use the Up/Down [
tons to select "a. Position," and
then use the Left/Right [
ENTER
buttons to select:
Main: Select if the IR receiver is
Zone 2: Select if the IR receiver is
5
Press the [SETUP] button.
The setup menu closes.
48
]/[
] but-
]/[
] but-
:Main
:1
Quit:[SETUP]
]/[
] but-
]/[
located in the main room.
located in, and will be used to
control Zone 2.
Note:
• This procedure can also be performed by using the
TX-NR901's [SETUP] button, [
buttons, and [ENTER] button.
Changing the TX-NR901's Remote Control
ID
This section explains how to change the TX-NR901's
remote control ID. You may need to change this if the
TX-NR901's remote controller interferes with other
Onkyo components located in the same room.
Note:
If you change the TX-NR901's remote control ID, be
sure to select the same ID on the remote controller
(page 49). The default ID for both the TX-NR901 and
remote controller is 1.
1
Press the scroll wheel, and then
press the [SETUP] button.
The main menu appears onscreen.
2
Use the Up/Down [
tons to select "0. Hardware
Setup," and then press the
ENTER
[ENTER] button.
The Hardware Setup menu appears.
ENTER
3
Use the Up/Down [
tons to select "3. Remote Setup,"
and then press the [ENTER] but-
ENTER
ton.
The Remote Setup menu appears.
]
ENTER
4
Use the Up/Down [
tons to select "b. Remote ID," and
then use the Left/Right [
ENTER
buttons to select an ID: 1
(default), 2, or 3.
]/[
]/[
]/[
]
]/[
] but-
]/[
] but-
]/[
] but-
]/[
]
Advertisement
Chapters
Table of Contents
