Overview; Interswitch Setup; A.1.1 Overview - JRC JMA-932B-SA User Manual

A.1
A.1.1

Overview

Interswitch NQE-3141 is equipment that enables free changeover between radar display units installed on the
bridge and antenna units having different characteristics.
Up to 8 units can be changed over.
When the connected scanner is changed, following setting values are automatically loaded.
Tune Adjustment
Bearing Adjustment
Range Adjustment
Antenna Height
Antenna installation location Section 7.1.9 "Setting of CCRP (CCRP Setting)"
Sector Blank
Performance Monitor
PRF Fine Tuning
A.1.2

Interswitch Setup

Connection modes can be changed simply by changing the interswitch connection (upper left of the display
on page 2-16).
Note: A master display unit is always necessary for establishing a slave connection.
Before a slave display unit can be placed in transmission state, the master display unit must be placed
in transmission state.

OVERVIEW

Section 7.1.3 "Tuning (Tune Adjustment)"
Section 7.1.5 "Bearing Adjustment"
Section 7.1.6 "Range Adjustment"
Section 7.1.8 "Antenna Height Setting (Antenna Height)"
Section 7.2.1 "Sector Blank Setting (Sector Blank)"
Section 7.3.3 "Adjustment of Performance Monitor (MON)"
Section 3.8.3 "Set Scanner Unit (TXRX Setting)"
A-1