JRC JMA-932B-SA User Manual page 367

[3] Check of Communication Lines (Line Test)
Checking the status of communications with options.
When no abnormality is found, "OK " is displayed.
When an abnormality is found," NG" is displayed.
The status display field of equipment not connected is left blank.
[4] GPIO Test
Testing of state of contact input to radar terminal board(CQD-2128).
Display of state of contact input to radar terminal board.
ARPA ACK IN
RADAR ACK IN 1
RADAR ACK IN 2
Changing ON/OFF of state of contact output to radar terminal board.
ARPA ALM
RADAR CONTACT 1
RADAR CONTACT 2
RADAR CONTACT 3
Notice: The GPIO test menu is displayed since display unit software Ver, 1.01.
[5] System Monitor
Monitoring the state of radar system.
Active mark
：State of contact input to radar terminal board "ARPA ACK IN".
ON/OFF
：State of contact input to radar terminal board "ARPA ACK IN 1".
ON/OFF
：State of contact input to radar terminal board "ARPA ACK IN 2".
ON/OFF
：Test of contact output to radar terminal board "ARPA ALM".
ON/OFF (Checked or Unchecked)
：Test of contact output to radar terminal board "RADAR CONTACT 1".
ON/OFF (Checked or Unchecked)
：Test of contact state to radar terminal board "RADAR CONTACT 2".
ON/OFF (Checked or Unchecked)
：Test of contact state to radar terminal board "RADAR CONTACT 3".
ON/OFF (Checked or Unchecked)
Active mark
Active mark is displayed if connecting the devices. The side
of the check box also turns on.
Recheck button
Click this button when rechecking of radar system.
Close button
Click this button when closing system monitor menu.
When no abnormality is found, "OK " is displayed.
When an abnormality or disconnection is found ," NG" is
displayed.
8-12
8.4 Performance Check
8 8 8