Card Stock - Lexmark X644e User Manual

• Do not load labels with paper or transparencies in the same source; mixing print media can
cause feeding problems and print quality problems.
• Do not use label sheets with a slick backing material.
• Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a
jam. Partial sheets also contaminate the MFP and your cartridge with adhesive, and could
void the MFP and cartridge warranties.
• Use labels that can withstand temperatures of 230°C (446°F) without sealing, excessive
curling, wrinkling, or releasing hazardous emissions.
• Do not print within 1 mm (0.04 in.) of the edge of the label, of the perforations, or between die-
cuts of the label.
• Do not use label sheets that have adhesive to the edge of the sheet. We recommend zone
coating of the adhesive at least 1 mm (0.04 in.) away from edges. Adhesive material
contaminates the MFP and could void the warranty.
• If zone coating of the adhesive is not possible, a 1.6 mm (0.1 in.) strip should be removed on
the leading and driver edge, and a non-oozing adhesive should be used.
• Remove a 1.6 mm (0.1 in.) strip from the leading edge to prevent labels from peeling inside
the MFP.
• Portrait orientation is preferred, especially when printing bar codes.
• Do not use labels that have exposed adhesive.

Card stock

Card stock is single ply, and has a large array of properties, such as the moisture content, thickness,
and texture, that can significantly affect print quality. See
the preferred weight and for the grain direction of print media.
Try a sample of any card stock you are considering using with the MFP before purchasing a large
quantity.
After printing approximately 10,000 pages of card stock (or each time you replace the print
cartridge), complete the following steps to maintain MFP feeding reliability:
1
Print five sheets of paper.
2
Wait approximately five seconds.
3
Print five more sheets of paper.
When printing on card stock:
• Set the Paper Type menu item in the Paper menu to Card Stock from the control panel, from
the MFP driver, or from MarkVision Professional.
• Be aware that preprinting, perforation, and creasing can significantly affect the print quality
and cause print media handling or jamming problems.
Supported print media
105
for information on