Notice To Users Of The New Zealand Telephone Network; Using This Product In Switzerland - Lexmark X644e User Manual

Notice to users of the New Zealand telephone network

The following are special conditions for the Facsimile User Instructions.
The grant of a telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It indicates no
endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it
provides no assurance that any item will work correctly in all respects with another item of
telepermitted equipment of a different make or model, nor does it imply that any product is
compatible with all of Telecom's network services.
This equipment shall not be set up to make automatic calls to the Telecom's 111 Emergency Service.
This equipment may not provide for the effective hand-over of a call to another device connected to
the same line.
This equipment should not be used under any circumstances that may constitute a nuisance to other
Telecom customers.
Some parameters required for compliance with Telecom's telepermit requirements are dependent on
the equipment associated with this device. The associated equipment shall be set to operate within
the following limits for compliance to Telecom's specifications:
• There shall be no more than 10 call attempts to the same number within any 30 minute period
for any single manual call initiation, and
• The equipment shall go on-hook for a period of not less than 30 seconds between the end of
one attempt and the beginning of the next call attempt.
• The equipment shall be set to ensure that automatic calls to different numbers are spaced
such that there is not less than 5 seconds between the end of one call attempt and the
beginning of another.
South Africa telecommunications notice
This modem must be used in conjunction with an approved surge protection device when connected
to the PSTN.
Using this product in Germany
This product requires a German billing tone filter (Lexmark part number 14B5123) to be installed on
any line which receives metering pulses in Germany. Metering pulses may or may not be present on
analog lines in Germany. The subscriber may request that metering pulses be placed on the line, or
can have them removed by calling the German network provider. Normally, metering pulses are not
provided unless specifically requested by the subscriber at the time of installation.

Using this product in Switzerland

This product requires a Swiss billing tone filter (Lexmark part number 14B5109) to be installed on
any line which receives metering pulses in Switzerland. The Lexmark filter must be used, as
metering pulses are present on all analog telephone lines in Switzerland.
183