Disassembly And Assembly Of The Camera Base - FLIR Navigator II Installation Manual

Disassembly and Assembly of the Camera Base – FOR STATIC CONFIGURATION ONLY
If you are mounting the camera with wood screws, it may be necessary to partially or completely remove the base from the
camera in order to securely attach the base to the vessel. With the camera removed, there is a
screwdriver access hole for each mounting screw in the base flange. Remove the camera from
its base as described in the following steps.
Note: Removing the camera from its base for installation may require that you disconnect
power wires from their terminal block and the video cable from its connector.
Step 1 Using a 2.5mm hex wrench, remove the six M4 socket head screws attaching the
camera to its base (only four screws are shown in Figure 3-7). Carefully separate the camera
from its base. There is a small service loop between the camera and the base.
Step 2 Disconnect the conductors at the cable side of the terminal
block. Note the wire color code for reconnecting the wires to the
terminal block.
Step 3 With the camera removed from its base, using the self-tapping
screws supplied, continue with the installation as described above. To
reassemble the camera to the base, continue with the following steps.
Step 4 Reconnect the four conductors and shield to the cable side of
the terminal block.
Note: To ensure a lasting seal, apply loctite 635 or equivalent to the
M4 screws holding the camera to its base.
Step 5 Reposition the camera on its base, ensuring that the front window is facing the correct direction.
Step 6 Apply loctite to the six M4 button head screws and using a 2.5mm hex wrench, alternately tighten the screws to
secure the camera in place.