Static Configuration; Before You Begin - FLIR Navigator II Installation Manual

STATIC CONFIGURATION

Thank you for buying your new Navigator II! If you need help during the installation
process, call 888.747.3547 to speak with one of FLIR's Applications experts.
A qualified marine electronics technician should install your Navigator II, as incorrect
installation could void your warranty.
Introduction
Your static Navigator II comes with these standard components:
• Camera head
• 25' system cable that goes from the camera head to the On/Off switch and customer-supplied Monitor
• 25' video cable
• On/Off switch
• Mounting hardware (machine screws, washers, lock washers, and
hex nuts)
You may need to supply:
• 16-gauge electrical wire from the vessel's power control panel to
the Navigator II's On/Off switch; maximum run of 100'
• Miscellaneous electrical hardware and connectors
• Camera base mount or shims (see below)

Before you begin:

•
Find a good place to mount the Navigator II
o Mount the Navigator II as high as practical, but without
interfering with any radar, navigational or communications